Price: ₹4,905.90 - ₹3,066.19
(as of Jul 06, 2025 10:23:05 UTC – Details)
Specification:
Condition: 100% Brand New
Working Voltage: 12V
Working Current: 0.5-0.7A
Flow: 1.5-2L/min (approx.)
Maximum Suction Range: 2m
Maximum Hydraulic Head: 3m
Life: 2500h(maximum)
Water Temperature: 80
Weight: Approx. 110g / 3.9oz
Size: Approx. 10 * 6 * 3.5cm / 3.9 * 2.4 * 1.4in
Package List:
1 * Pump
Note:
There is silicone cover in the back of the pump, do not cover the motor’s cooling hole to avoid affecting the heat dissipation and service life.
【Self Priming】 : Water Pressure Diaphragm Pump allows for usage even if located above water tank.
【Convenient and Hygienic】:The sealed pump body prevents accidental moisture and dust from entering and is easy to install and maintain.
【Good Performance】:It is small in size, rugged and the maximum suction range can be up to 2m.
【High Quality】: The diaphragm pump is made of high quality material with stable rotation, low noise and long service life.
【Widely Used】 :The water pump is widely used for tea machine, water cooling, fish tank, and other fields.
Jluck –
Been using it for live well pump with salt water on the ocean.
Wombat37 –
I like using this type of pump for transferring homemade beer, wine, and mead between various vessels. Using a siphon is a real pain. These diaphragm pumps are self-priming, food safe, and donât pull air into the liquid stream. This pump from Hyuduo is similar to one I ordered earlier but at about half the price. I connected it up to a lab power-supply and did a few tests.The rated flow rate of 1.5 â 2.0 liters/min is ideal for my needs. The pump functioned over a wide range of DC voltages 6 â 12V. Itâs very noisy unless liquid is passing through it, so it doesnât seem to be suited for use as an air pump. At 12V there was a strong flow of liquid and the pump was very quiet. Under moderate load, it drew 500mA and so it shouldnât be a challenge to most power supplies.The motor has solder terminals and so will need a soldering iron to get it going. There are two soft rubbery motor mounts that can be screwed to a baseboard to position the pump without producing a lot of noise.So far, this pump is working very well. I just wonder why it is half the price of my earlier order.
MSvendsen –
My car has a head gasket leak. I pump water into radiator using a ten foot 1/4 inch hose from inside the car and 3gal. jug. Pump can build pressure enough to overcome radiator cap seal unless I bend the tabs to make the seal really tight. It started to leak after little use, maybe 20 gallons.
E. Fisher –
This product is a self priming pump and nothing else. No tubes, no power connection wires, no mounting screws. Nonetheless, the pump itself functions well. I had to solder wires with two terminal clips to connect the pump to my boat battery to pump the bulge where water collects that is too low to be pumped out with the boat’s bulge pump. This pump does the job fine. It’s best feature is it is self-priming. And that is a HUGE feature. Last year I purchased a pump that was big with accessories — wires, plastic and copper tubes, etc, but it was not self-priming. What a pain to prime a pump when the input tube has to be transferred to the bottom of a boat bulge without introducing bubbles into the tube. Ugh. But this pump is easy-peasy by comparison. I am glad I ordered it!